RM-LVR1 system software for Windows

Details

1. Download the update file
   Download the file to your computer. Please save the downloaded file onto the Desktop of your computer (recommended).
   
   For Windows 8 users:
   Under the initial settings of Internet Explorer, the update file will be saved in the Downloads folder. Click the Desktop tile from the Start screen and find the downloaded file in the Downloads folder by using Explorer.
   
   

2. Start up Firmware Updater
   • Close all currently running programs on your computer.
   • Double click the downloaded file Update_RMLVR1V200.exe to start up Firmware Updater.
   • Firmware Updater starts up.
     
     
     
     
3. Connect the camera to the computer
   1. Connect the camera to the computer with the supplied USB cable.
      Note: "USB Mode” appears on the LCD monitor of the camera. Please proceed to the next step.
      
      If the computer cannot find the camera, the message “ Could not find the camera for this update.” appears on the computer display. Try the following if this happens.
      - Disconnect the USB cable and connect it again.
      - If the computer has multiple USB terminals, try with the other terminals. (Your computer may have some USB terminals on the backside.)
      
      Sometimes when the camera is connected to the computer with the USB cable, the message to encourage rebooting the computer may appear on the computer display. In this case, remove the battery pack from the camera, reboot the computer, and follow the procedures from “Start up Firmware Updater“.
      
      
   2. Confirm is displayed on the task tray at the lower right corner of the computer screen.
      
      
   3. After confirming the above, click Next on Firmware Updater.
      Screen of Computer
      
      
      

      LCD screen of the device

      
      
      Note: From this step onwards, never turn off the camera until the firmware upgrade is completed.
      
      
4. Check if the updating is required
   1. After confirming the screens on the above steps, click Next.
      The current version and the version after the upgrade appear on the lower left part of the screen.
      Upgrade is required
      
      
      If the screen below appears, the upgrade is not required. According to the message, stop the USB connection and click Finish.
      
      
      
      
   2. After confirming Current version is Ver. 1.00, click Next.
      
      
5. Reset the camera
   • 1. Click on the task tray at the lower right corner of the computer screen to stop the USB connection.
        
        Notes:
        - Please keep the USB cable connected even after stopping the USB connection on the computer with the above operation.
        
        
        
     2. Press the REC/ENTER button to execute.
        
        
        Note: The screen turns off when the REC/ENTER button is pressed. Please proceed to the next step.
        
     3. Click Next on Firmware Updater.
        
        
        
6. Start the update
   
   1. After resetting, reconnection of the camera is verified, and the screen below appears.
      
      
   2. Click Run to start the upgrade. The progress bar appears while upgrading (approximately 10 minutes).
      
      Note: Never turn off the camera nor disconnect the USB cable while upgrading.
      
      
7. Complete the update
   When the upgrade is completed, the screen below appears. Click Finish and disconnect the USB cable.
   
   
   Note: Turn off the device and then turn on the device again.
   
   
8. Check the firmware version
   Follow the instruction to confirm the firmware version is Ver. 2.00.
   1. Press MENU button to select Main Settings, then press REC/ENTER button.
   2. Press Version then press the REC/ENTER button. If the display changes as shown below. then the system software version is Ver.2.00.